Blaupunkt CASUAL 845, Instruction Manual

Page: 32 / 68

Einstellen Garnrollenstift
Ziehen Sie den Garnrollenstift.
Legen Sie die kürzere Seite
des Garnrollenstift in die hine.
EN
Removing or Inserting the Bobbin Case
Pull out the spool pin. Insert the
shorter side of spool pin into the
machine.
Open the hook cover.
Cross the cotton in a figure of
eight for good tension
Draw the thread from the spool. Guide the thread around the bobbin winder thread guide.
Insert the thread through one of the holes in the bobbin
Put the bobbin on the bobbin winder spindle, and push it to the right. This will disengaged the machine and engage the spooli
With the free end of the thread held in your hand, depress the foot control. Stop t
close to the hole in the bobbin. Depress the foot control again.
When the bobbin is fully wound, it will stop automatically.
Return the bobbin winder to its original position by moving the spin
32
Setting spool pin
Winding the Bobbin
Removing or Inserting the Bobbin Case
Switch off the machine while doing this!
Open the hook cover.
Raise the needle by turning the
balance wheel toward you.
Take out the bobbin case by holding
the latch.
When inserting the bobbin case,
place the horn into the recess of the
hook race.
Switch on the machine.
spool. Guide the thread around the bobbin winder thread guide.
Insert the thread through one of the holes in the bobbin from the inside to the outside.
Put the bobbin on the bobbin winder spindle, and push it to the right. This will disengaged the machine and engage the spooli
With the free end of the thread held in your hand, depress the foot control. Stop the machine when it has made a few turns, and cut the thread
close to the hole in the bobbin. Depress the foot control again.
When the bobbin is fully wound, it will stop automatically.
Return the bobbin winder to its original position by moving the spindle to the left, and cut the thread.
Inserting the Bobbin Case
Switch off the machine while doing this!
When inserting the bobbin case,
place the horn into the recess of the
hook race.
Switch on the machine.
Put the bobbin on the bobbin winder spindle, and push it to the right. This will disengaged the machine and engage the spooling facility.
he machine when it has made a few turns, and cut the thread
Inserting the Bobbin Case