Blaupunkt BB16BK, Owner'S Manual

Page: 11 / 164

Power source
This unit is designed to be operated both with AC and with DC.
AC operation
Plug the tail of AC power cord into AC jack on unit and the cord into AC wall outlet. The
batteries will be automatically disconnected.
DC operation
Open the BAT TERY COMPARTMENT DOOR. Install 6 pcs UM-1/D size batteries (not included)
into compartment. Please follow correct polarities as indicated.
Caution
Remove batteries if they are flat or not being used for a long time.
Batteries contain chemical substances, so they should be disposed of properly.
Basic function
Switching on the unit
After connecting the power, press standby/function button to turn on the unit, then press the
standby/function button again to choose CD /USB/ AUX/TAPE or RADIO mode. Long press
standby/function button to turn off the unit.
NOTE : In CD/USB/AUX/TAPE mode, when the unit is not providing the main function for 60
minutes, the unit will automatically switch into standby mode. In the tape mode, only the tape
stops for 60 minutes, the unit will automatically switch into standby mode. To turn on the unit
again, press standby/function button or re-plug the unit.
ESD hints – The product maybe reset or not reset to operation of control due to electrostatic
discharge, just switch off and reconnect again.
Adjust volume
Press VOL.+/- button to increase or decrease volume.
Headphone jack
For private listening, connect a 3.5mm headphone (not included) to the headphone jack. The
speaker output will be automatically disabled.
Caution: listening at a high volume over a long period is not good for your ears.
Using the radio
Before start the radio listening, please full extent the FM antenna and try to move the unit next
to window in order to get better signal reception; press the standby/function enter to the FM
radio mode.
1. FM tune and scan: short press Tune +/- button to increase or decrease the FM frequency per
0.05MHz. Press and hold Tune +/- button 2 seconds to auto scan and play the available
station in upward or downward frequency; press and hold it again to scan the next station.
2. FM manual preset memory: when you tuned a favorite by Tune +/- button, press
Program/memory/play mode button to start the preset program; press 10/fold./M.- or
10/fold./M.+ button to switch the preset station number (Max supported 40 preset stations)
that you want to save, press program/memory/play mode button again to confirm your
selection; then the station will be saved as your selected preset number.
3. All-in-one scan (auto scan and preset station up to 40): short press the play/pause button to
scan and save the available station automatically; short press 10/fold./M.- or 10/fold./M.+
button to pick up the preset station.
Cassette operation
Playback of cassette
Be sure to tighten any slack tape in the cassette before using, use either a pencil or a ball-point
pen, simply insert the pen or pencil into the center of spool and rotate to remove slackness.
Press the STOP/EJ button to open the cassette door.
Insert the cassette into the compartment with the open end facing upwards and the full reel on
the left hand side, push the cassette well down and close the door, be sure not to touch the tape
surface, Set the function switch to “TAPE” and press the cassette play button. To stop playback,
press the STOP/EJ button once. To release the cassette, press the STOP/EJ button again.
BB16BK/BB16WH
9