Setting the clock
Turn On Message
This unit offers you the possibility to enter a
Set the clock in the DSC mode.
l
Press DSC briefly.
turn on message of up to 40 characters. The
message will briefly appear in the display
each time you turn the unit on.
l
Press v to select the function
Proceed as follows:
“CLOCKSEP.
l
Press
to activate the hours or
Select the DSC mode.
_
the minutes. The option you can set
will flash.
.
l
Press
to alter the flashing
.
display.
.
l
When you have completed the setting,
press DSC briefly to store it.
.
l
Press DSC again to exit DSC mode.
.
Press DSC.
Press
A
v to select TOM.
Press
to turn the message off.
Press
two times to select the edit
mode.
If there is no
TOM programmed,
dashes
will appear in the display.
The cursor will flash at the current
position. Press
to move the
cursor.
Press v to select a character. If you
want to enter a blank, select the dash
Press DSC to store the message.
Press DSC again to quit the DSC
mode.
If you want to change the message, select
TOM in the DSC mode and overwrite it in
the edit mode. If you want to change just a
few of the letters, press
to move the
cursor to the corresponding position and
change that character only.
DSC programming
The car radio has been equipped with DSC
(Direct Software Control) to allow you to
customize certain programmable, basic
settings to suit your personal needs and
preferences and then store them.
The basic settings for this car radio were
made at the factory.
In the following you can find an overview of
these settings, so that you can always reset
to them if desired.
If you wish to alter any of the programming,
l
press DSC.
MENU v
A
will temporarily appear in the
display.
Use the
A
v buttons of the rocker switch
to select the function you wish to change.
The display will show you the setting you
have selected. Press the
buttons of
the rocker switch to change the settings and
exit the current mode. Confirm the setting
you have selected by pressing the DSC
button.
A V
Select function
setting
1 6
