www.blaubergventilatoren.de
Ceileo DC
12
The fan maintenance includes regular cleaning of the surfaces of dust and dirt. Replace the filter as required, but at least every 6 months.
The impeller cleaning is shown below. Clean the impeller blades thoroughly every 6 months.
SETUP OF THE OPERATION MODES
AND
: the fan is turned off.
“60”, “70”, “80”, “90”, “100”, “110”, “120”, “130”, “140”, “150”: the fan runs to keep permanent air flow with set air capacity settings. The settings
are displayed in CFM.
The maximum air flow value is limited to 110 or 150 CFM, depending on the fan model.
“120”, “130”, “140” and “150” air flow values are not available for the fan with the air capacity 110 CFM.
Example 1
=
,
=
: with these activated settings the fan runs to keep the air flow 60 CFM. Once the switch is turned on or a
sensor is activated, the fan starts to run with the maximum capacity.
That is a factory setting for the fans with the maximum air capacity 110 CFM.
=
is applied for the fans with the maximum air capacity 150 CFM.
Example 2
=
,
=
: with these activated settings the fan is off. Once the switch is turned on or a sensor is activated, the fan starts
running to keep the air flow 90 CFM.
This way by changing the
and
parameters you can set a required operation mode.
DISCONNECT THE UNIT FROM POWER SUPPLY BEFORE ANY MAINTENANCE
OPERATIONS!
MAKE SURE THE UNIT IS DISCONNECTED FROM POWER MAINS BEFORE REMOVING
THE PROTECTION
TECHNICAL MAINTENANCE
