www.blaubergventilatoren.de
vento expert a50c3-1 S8 W v.2
21
Press and hold the
Ventilation
button on the master ventilator casing. Wait for the beep and the blinking of all the LEDs on the
CONNECTING MASTER AND SLAVE VENTILATORS
SPECIAL SETUP MODE
BATTERY REPLACEMENT
unit casing. Repeat the steps with all the slave ventilators and wait for the beep when all the LEDs stop blinking on each Slave unit. Set
the Master unit to the standard operation mode. Press and hold the
Ventilation
button. Wait for the beep when all the LEDs stop
blinking.
Note:
if the home router works in conjunction with several Wi-Fi access points requiring connection of ventilators to different access
points:
• Connect the Master unit to the first Wi-Fi access point.
• Complete the connection with the first group of Slave units.
• Connect the Master unit to the second Wi-Fi access point.
• Complete the connection with the second group of Slave units.
In the event of losing the Wi-Fi password or the master ventilator password or in other cases, use the special Setup mode to restore access
to the ventilator functions. To enter the special Setup mode, press and hold the
Ventilation
button on the ventilator casing for
5 seconds until the beep and blinking of all the LED lights.
The ventilator will continue in this mode for 3 minutes and then automatically revert to the previous settings. To exit the Setup mode
immediately, press and hold the
Ventilation
button on the ventilator casing once again for 5 seconds until the beep and shutdown
of all the LED lights.
In this mode the following settings are available:
•
Wi-Fi network name
: Setup mode.
•
Wi-Fi password:
11111111.
•
The unit password is ignored.
The
Alarm
indicator on the unit casing will blink when the battery
is approaching the end of its life. The mobile app will also display
the
warning and show the following message on pressing the
indicator icon.
Low battery power may cause disruptions in the weekly schedule
operation. Power off the unit before replacing the battery. After
replacing the battery reset the time and date.
The battery is located on the control circuit board. To replace the
battery, power off the ventilator, remove the front panel and the
cover protecting the control circuit board. Remove the battery and
install the new one.
Battery type:
CR1220.
AFTER CHANGING THE WI-FI PARAMETERS OF THE MASTER VENTILATOR REPEAT THE
CONNECTION STEPS!
WHILE COMPLETING THE CONNECTION MAKE SURE THAT THE SLAVED VENTILATORS
ARE WITHIN WI-FI COVERAGE OF THE MASTER VENTILATOR
