Page 15
220E OPERATING CONTROLS
OPERATING AROUND THE CORD (FIGURE A)
The extension cord should be properly fed through the clip on the end of the flip arm cord guide. Loop
cord once. See the Cord Hook Up in the manual. The flip arm cord guide is designed to keep track of the
location of the electrical cord, especially when backing up and turning.
• Keep cord to side and slightly forward.
• Always work away from the cord.
• When backing up or making a sharp turn, check the location of the cord.
• Flip arm moves from side to side to help to keep electrical cords from being ran over (See Figure B).
• Adjust the flip arm cord guide in confined areas. Center position is achieved by moving cord guide arm
to the 12 o’clock position and securing in place with pin (See Figure C). This is used when going
through doorways or hallways. Hold cord straight out the back of the machine.
Figure C
WARNING:
Disarm machine by removing the cutting head or dropping the cutting head to the floor
when the machine is not in use.
Figure A
Figure B
CAUTION:
Do not run over cord. Doing so could cause damage to equipment or severe
bodily injury.
