16
Make sure that no vehicles, such as forklift trucks and other equipment run over the electric cable and the dust
hose.
The selection of the correct advancing speed of the machine is important for a good result. In the case that the
surface has different characteristics (e.g. different hardness or different coating thicknesses), a uniform result
can be achieved by varying the advancing speed during scarifying / milling.
The advancing speed depends on the material of the surface to be treated and the desired profiling.
The correct advancing speed can be found out by observing the treated surface and varying the speed during
the scarifying / milling process.
Slight profiling on concrete requires a higher speed than coarse profiling.
5.4
Switch off the machine
Pull the quick lift lever up and turn the fine adjustment till the drum does not hit the ground anymore.
Push the red button (BMP-215E) or switch the On-Off button at the front of the petrol motor to Off.
(BMP-215B)
Switch off the dust collector.
Disconnect the power supply.
Pay attention that all twisting and turning machine parts have reached a standstill before inspection or
maintenance duties are carried out.
