MODEL BDC317P DUST COLLECTOR
OPERATING MANUAL
APRIL 2008
SECTION 6
OPERATION
30
Dust Collectors
6.3 EMPTY THE HOPPER
The level of the hopper must be regularly checked. The frequency of checks will
be determined upon the surface to be cleaned.
Figure 6.1 (Similar Machine)
After finishing the blast cleaning process or other process, the dust
collector must run several minutes to clear the filter cartridges.
After several minutes, set the main switch of the dust collector to "0".
Wait a few minutes so that the dust falls to the bottom of the dust bin.
Pull the sliding handle (Item 4) about 180° upwards, see arrow. The dust
bin (Item 1) will let down.
Hold the handle of the bin (Item 2) to take it out and to empty it.
Then re-install the dust bin. The handle (Item 2) must point away from the
machine, as shown. Next, adjust the sliding handle (Item 4) into the initial
position.