1) BURNERS
A diagram is screen-printed above each knob on
the front panel. This diagram indicates to which
burner the knob in question corresponds. After
having opened the gas mains or gas bottle tap, light
the burners as described below:
- manual ignition
Push and turn the knob corresponding to the
required burner in an anticlockwise direction until it
reaches the full on position (large flame fig. 1), then
place a lighted match near the burner.
- Electrical ignition
Push and turn the knob corresponding to the
required burner in an anticlockwise direction until it
reaches the full on position (large flame fig. 1), then
depress and release the ignition button.
- Automatic electrical ignition
Push and turn the knob corresponding to the
required burner in an anticlockwise direction until it
reaches the full on position (large flame fig. 1), then
depress the knob.
- Lighting burners equipped with flame failure
device
The knobs of burners equipped with flame failure
device must be turned in an anticlockwise direction
until they reach the full on position (large flame
fig. 1) and come to a stop. Now depress the knob in
question and repeat the previously indicated
operations.
Keep the knob depressed for about 10 seconds
once the burner has ignited.
Note:
you are advised not to try and light a burner if
the flame divider (Burner Cap) is not correctly
placed.
HOW TO USE THE BURNERS
Bear in mind the following indications in order to
achieve maximum efficiency with the least possible
gas consumption:
- use adequate pans for each burner (consult the
following table and fig. 2).
- When the pan comes to the boil, set the knob to
the reduced rate position (small flame fig. 1).
- Always place a lid on the pans.
Burners
Power ratings
Pan Ø in cm
Natural
U-LPG
Ultra rapid
or
Wok
14.5 MJ
11.4 MJ
22 - 24
Rapid
12.0 MJ
10.4 MJ
20 - 22
Semi-rapid
7.1 MJ
6.3 MJ
16 - 18
Auxiliary
4.1 MJ
3.6 MJ
10 - 14
WARNINGS:
- burners with flame failure device may only be
ignited when the relative knob has been set to the
Full on position (large flame fig. 1).
- Matches can be used to ignite the burners in a
blackout.
- Never leave the appliance unattended when the
burners are being used. Make sure there are no
children in the near vicinity. Particularly make sure
that the pan handles are correctly positioned and
keep a check on foods requiring oil and grease to
cook since these products can easily catch fire.
- Never use aerosols in the vicinity of this appliance
while it is in operation.
- If the built-in hot plate has a lid, any spilt food
should be immediately removed from this before it
is opened. If the appliance has a glass lid, this
could shatter when the hot plate becomes hot.
Always switch off all the burners before closing
the lid.
- This appliance is not to be installed in marine craft.
-Not for use in caravans or mobile homes unless
each burner is fitted with a flame safeguard.
Where this appliance is installed in a caravan, it
shall not be used as a space heater.
- Do not store or use flammable liquids or items in
the vicinity of the hotplate.
- Do not modify this appliance.
3
USE
FIG. 1
FIG. 2
