background image

 

End Cap 

Clear Tube 

Cover 

UV Tube 

 

Introduction 

 

Ultraviolet light is electromagnetic radiation in the segment of the 
spectrum between X-rays and visible light, approximately 180nm to 
400nm. It differs from visible light in that its wavelengths are too short 
to be seen by the human eye.   
 
UV-A, or longwave radiation, is 315nm and above. UV-B, or midrange 
radiation, is 280nm-315nm. UV-C, or shortwave radiation, is 280nm 
and below.   
 
When UV radiation falls upon phosphors, it causes the phosphors to 
emit specific radiation. This is known as fluorescence. In some 
materials, the fluorescence lingers on and slowly disappears after the 
UV source is removed. This phenomenon is known as 
phosphorescence. 
 

CAUTION:

 SHORTWAVE UV IS HARMFUL TO THE EYES AND 

SKIN. PROPER PROTECTION MUST BE WORN WHEN 
OPERATING A LAMP EMITTING SHORTWAVE UV. 

 
 

Tube Replacement 

 

1.  Remove the batteries prior to replacing the tube.  
2.  Pull off the circular bulb cover and end cap on the end of the unit, 

followed by the clear tube cover. 

3.  Gently twist the tube by the base to release the tube. 
4.  Replace with a 4 watt longwave tube.  
5.  Replace the clear cover.  
6.  Reconnect the end cap and bulb cover back into position. 
  

 
 

 

 

 

 
 
 
 
 
 

 

CAUTION

:  DO NOT EXPOSE EYES OR SKIN TO SHORTWAVE 

ULTRAVIOLET LIGHT, AS RAYS MAY BURN UNPROTECTED EYES OR 
SKIN (UVG-4, UVSL-14P). UV BLOCKING EYEWEAR IS RECOMMENDED. 

 

 

 

 

 

 

 

 

Replacement Parts 

 

 

Part Number 

365nm UV (for UVL-4) 

 

 

34-0010-01 

254nm UV (for UVG-4) 

 

 

34-0003-01 

254/365nm UV (for UVSL-14P) 

 

34-0004-01 

 
Spectacles 

 

 

 

98-0002-01 

Goggles  

 

 

 

98-0002-02 

 
 

Battery Replacement 

 

The UVL-4, UVG-4 and UVSL-14P all operate on four (4) standard 
AA batteries. Some alkaline batteries with test strips are slightly larger 
than standard batteries and may cause a tight fit. Recommended 
batteries for use in the Mini UV Lamps are Eveready Classic and 
Rayovac without test strips. 
 

To replace the batteries:

 Press the center of the battery housing 

closure toward the back of the lamp and slide the hinged door forward 
and up. Insert the 4 AA batteries, orienting the batteries as indicated 
below. Close the door.   
 

 

 

 

 

NOTE: 

Remove the batteries if the unit is to be stored for more than a 

few months without use. 

Bulb Cover 

 

Battery Orientation 

Battery Replacement (UVL-4 Shown) 

 

Reviews: