12
EN
LED Codes
Using the Gimbal
1. Place the quadcopter on a fl at and stable surface.
Ensure there are no obstructions in the path of the
GB200.
2. Switch on your transmitter.
3. Switch on your quadcopter. The GB200 will power
on with the quadcopter.
NOTICE:
You must have a camera mounted to the
GB200 for the gimbal to initialize properly.
After the gimbal initializes, the LED will glow purple
for approximately 3 seconds. In those 3 seconds, the
camera mount may be rotated up or down by hand
to your desired neutral pitch position. When the LED
changes to green or blue, the neutral position is set
and the GB200 is ready for use.
The gimbal will now compensate for any roll and pitch
movements encountered by your quadcopter.
If desired, you may change the pitch angle of
the gimbal at any time using your programmed
transmitter controls.
Green
Red
Blue
Purple
Angle Mode
No control(Power Only)
350 QX2/AP Port Connected
Remote Receiver Connected
Velocity Mode
No control(Power Only)
350 QX2/AP Port Connected
Remote Receiver Connected
Initialization Complete
Neutral Position Change Available
No Gyro Data
Summary of Contents for GB200
Page 1: ...1 EN GB200 2 Axis Brushless Gimbal ...
Page 15: ...15 EN ...
