23
EN
Problem
Possible Cause
Solution
LED on receiver fl ashes rapidly
and aircraft will not respond to
transmitter (during binding)
Transmitter too near aircraft during
binding process
Power off the transmitter. Move the
transmitter a larger distance from the
aircraft. Disconnect and reconnect the
fl ight battery to the aircraft. Follow the
binding instructions
Bind switch or button was not held
while transmitter was powered on
Power off transmitter and repeat bind
process
Aircraft or transmitter is too close to
large metal object, wireless source or
another transmitter
Move aircraft and transmitter to another
location and attempt binding again
LED on the receiver fl ashes
rapidly and the nano QX will
not respond to the transmitter
(after binding)
Less than a 5-second wait between
fi rst powering on the transmitter and
connecting the fl ight battery to the
nano QX
Leave the transmitter powered on.
Disconnect and reconnect the fl ight
battery to the nano QX
The nano QX is bound to a different
model memory (ModelMatch™
transmitters only)
Select the correct model memory on the
transmitter. Disconnect and reconnect the
fl ight battery to the nano QX
Flight battery or transmitter battery
charge is too low
Replace or recharge batteries
Aircraft or transmitter is too close to
large metal object, wireless source or
another transmitter
Move aircraft and transmitter to another
location and attempt connecting again
Crashes immediately
upon lift-off
Propellers in wrong locations or
incorrect fl ight mode selected
Make necessary adjustments
