7
EN
Binding
The transmitter is bound to the model at the factory. If
for any reason the model needs to be re-bound, follow
the directions below.
The Binding Process
1. With the transmitter and quadcopter powered off,
connect the battery to the 350 QX2 AP.
2. With the 350 QX2 AP on a level surface, turn on the
power switch and allow the quadcopter to initialize.
3. Wait until the blue LED on the quadcopter fl ashes
rapidly, signaling the quadcopter is initialized and
ready to bind.
4. Ensure the throttle is in the low position. Hold the
control sticks in the desired bind position
(see illustrations) and press and hold the bind but-
ton, then power on the transmitter.
5. Refer to the Flying LED Codes table to ensure the
aircraft is bound correctly.
Mode 2 shown
Normal Bind
Roll left
Yaw left
Roll right
Yaw right
Bind with GPS enabled
Bind in compass calibration mode
Bind with GPS disabled
Bind in pressure calibration mode
Bind button
IMPORTANT:
Do not attempt to bind with more than
one bind code. Binding with more than one bind code
will only allow the aircraft to bind normally.
Unless binding with a bind code, the elevator and
aileron inputs must be neutral during binding. If you
are attempting a normal bind with any input other than
neutral, the aircraft will emit a constant, rapid beeping
sound.
Transmitter Bind Codes
Entering Bind Mode
Summary of Contents for 350 QX2
Page 1: ...Instruction Manual ...