Blade 350 QX2, Instruction Manual

Page: 5 / 18

5 EN
The Battery Charging Process
1. Connect the AC power supply to the charger.
2. Connect the AC power supply to an AC power source.
The green LED blinks.
3. Connect the battery to the charger. The red LED
blinks, indicating charging. When the battery nears
full charge, the red and green LEDs blink, indicating
cell balancing.
4. Disconnect the battery when the green LED glows
solid.
Charging the Flight Battery
Charger Specifi cations
• Input Voltage: 10.5–15V DC
• Charge Current: 3.5A
LED Indications
Green Blinking: Ready to Charge
Red Blinking: Charging
Red & Green Blinking: Cell Balancing
Green Solid: Charging Complete
Red Solid: Error
CAUTION: Overcharging a battery can cause
a fi re.
NOTICE: If using a battery other than the included
Li-Po battery, refer to your battery manufacturer’s
instructions for charging.
1a 1b
2 3
Install the Gimbal
Install the Camera
1. Follow the instructions included with your camera to
charge the camera battery and install the micro SD
card (
not included ).
2. Slide the camera fully into the gimbal as shown.
3. Insert the Wi-Fi antenna through the mount and into the
camera body until it clicks. Rotate the antenna 90° in
either direction to lock the antenna and camera to the
mount.
4. Install the 3mm mounting screw to secure the CGO1 to
the mount.
Refer to the included camera and gimbal manuals for
operating instructions.
1
2
3 4
1. Slide the gimbal onto the mount as shown until it locks.
2. Connect the cable from the aircraft to the port on the
gimbal as shown.