BLACKMER IOM E Series, Installation, Operation & Maintenance Manual, Page: 41 / 52

1901-a00 41
INSTALL ROTOR ASSEMBLY INTO OUTER DRIVE ASSEMBLY
(E1-133 and E1-222 Models)
1. Secure the magnet housing firmly to a level surface.
MAG HOUSING ON LEVEL SURFACE
2. Install the canister into the magnet housing aligning the bolt holes. Orientation is irrelevant.
3. Install the rotor assembly into the canister, ensuring it is all the way seated into the rear of the canister. A block may be
required under the rotor head to ensure it stays parallel with the build surface during the following steps.
ROTOR INSTALLED INTO CANISTER
4. Thread the three (3) bearing housing jack screws into the bearing housing until the head bottoms out.
5. Orient the outer drive assembly to be in line with the back side of the magnet housing, ensuring the ends of the jack bolts
rest against the magnet housing. A block may be required under the outer ring to ensure it stays parallel with the build
surface during the following steps.
BEARING HOUSING IN POSITION
6. Slowly and evenly remove the jack screws from the bearing housing, which will allow the outer drive to slowly pull in to the
magnet housing.
7. Continue until the coupling has fully re-engaged.
COUPLING FULLY RE-ENGAGED
8. Install six (6) screws holding the bearing housing to the magnet housing.
9. Remove jack screws from the bearing housing.
10. Install jack screws into their storage location in the bearing housing foot.