Blackbelt 3D BV Blackbelt, Installation & User Manual, Page: 64 / 109

Version 2020-5.0_ENG
63
8. Take off the gantry and put it to the left besides the printer [13]
9. Set the base unit upright [14]
10. Loosen the rear roller with the rear 2 screws [14]
11. Unmount the rear roller while holding it with the other hand [15]
12. Remove the rear roller [16]
13. Remove the conveyor belt [17-18]
a. Move it carefully to the front, between the limitations
b. Now lift the front side of the belt above the mount of the front roller
14. Mount the new belt [19-20]
c. Check the belt direction
d. Carefully position the belt to the rear of the printer
e. Then put it over the front roller
15. Put back the rear roller inside the conveyor belt [20-21]
16. Mount the rear roller with the 2 rear screws. Turn at the short side of the Hexagon key to not overtighten
the belt.
[22-23]
15 16
0
17
18
0
13 14
0