Black BLK-CDS105NH, Instruction Manual

Page: 9 / 23

■
Installation Procedures
3. Remove the cover of the auto iris lens connector plug and solder the lens
cable to the connector pin of the plug.
4. Fit the cover of the auto iris lens connector plug, remove the protective
glass cover from the front of the camera, and fasten the auto iris lens
by turning it clockwise.
• For a Video Drive Lens
Pin 1: Red (Power)
Pin 2: NC
Pin 3: White (Video Signal)
Pin 4: Black (Ground)
• For a DC Drive Lens
Pin 1: Damping -
Pin 2: D
Pin 3: Drive +
Pin 4: Drive -
When Using C/CS Mount Lens
Before installing a lens, identify whether the lens to be installed is a C-Mount
or CS-Mount. This camera is set for a CS-Mount Lens by default. To install a
C-Mount Lens, a simple modification is required.
• When Using a CS Mount Lens
Remove the protective glass cover at the front of this product and turn the
CSMount Lens clockwise to install it. And set focus of camera using Back
Focus Control Lever of camera side after combining CS-Mount lens.
• Use the lens connector shown in the following figure. If the dimensions
of the connector are not correct, it may damage the camera, or the lens
may not be installed firmly.
• If the lens is too heavy, the camera becomes unbalanced and there may
be problems. Use a lens that weighs less than 450g.
• When adjusting the Automatic Level Control (ALC) of an auto iris lens,
use Av mode if available. If you use the Pk mode, the picture brightness
may change continuously.
Note
connector
Lens cable
No. 3 Pin
No. 1 Pin
No. 4 Pin
No. 2 Pin
C-Mount Lens: 10mm or less
CS-Mount Lens: 5mm or less
14 15
Super DNR High Resolution Day/Night Camera Super DNR High Resolution Day/Night Camera