Black BLK-CDS105NH, Instruction Manual

Page: 11 / 23

REMOTE
VIDEO OUT
DC VIDEO
POWER
SET
F.G
AC24V/DC12V D/N
IN G
M/D
OUT
UTP
OUT RS485
■
Installation Procedures
Since power specifications differ depending on the model, make sure to check
your model name and specifications before connecting power.
You can connect power as shown in the following figure.
• Since the power specification supports both AC and DC, connect AC 24V, 500mA
Adaptor or DC 12V, 500mA Adaptor.
When the resistance value of copper wire is at [20°C(68°F)]
• As shown in the table above, voltage decreases as the wire gets longer.
Therefore use of an excessively long adaptor output line for connection to
the camera may affect the performance of the camera.
※
Standard voltage for camera operation : DC 12V±10%, AC 24V±10%
※
There may be some deviation in voltage drop depending on the type of wire
and the manufacturer.
Control via RS-485 Interface Connecting Power
For AC / DC power
RS-485 Control Port 485 Control Board Connection Port
485+
(+) CONNECTION TERMINAL (TRX+)
(- ) CONNECTION TERMINAL (TRX-)
485-
Item
Initial value
PET PKT UART MODE BAUD RATE Camera ID
1 ENABLE 8-NONE-1 9600
#24(0.22mm
2
) Copper wire size(AWG) #22(0.33mm
2
) #20(0.52mm
2
) #18(0.83mm
2
)
Resistance value( /m) 0.018 0.030 0.050 0.078
Voltage drop(V/m) 0.006 0.011 0.018 0.028
The camera can be controlled by using external controllers like a Remote controller.
(RS-485 Communication)
• To control using a DVR or System Controller
Connect the RS-485 cable (TRX+, TRX-) to the connection port of the 485
control board that is connected to the DVR or System Controller.
* RS-485 Communication establishment initial value
• To control the camera by constructing an additional controller, use
Pelco-D protocol.
(Go Preset 95 : Enters into OSD menu or Set key function)
Note
18 19
Super DNR High Resolution Day/Night Camera Super DNR High Resolution Day/Night Camera
When using UTP Cable
• Connect UTP(Unshield Twisted Pair) wire to the UTP output of the camera
directly. UTP transmitter is included in the camera therefore additional UTP
transmitter is not necessary.
• UTP receiver is necessary to connect UTP wire to Monitor or DVR.
• When connecting UTP wire, make sure the polarity of the video signal
is correct.
• Use UTP wire "CAT 24AWG" to have the best transmission quality.