Black Max BM80915E, Operator'S Manual

Page: 17 / 56

Page 13 — English
To connect a nozzle to the trigger handle:

Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.
 Engage the lock out on the trigger handle by pushing up
on the lock out until it clicks into the slot.

Pull back the quick-connect collar.
 Push the nozzle into place in the spray wand.

Push the collar forward so that the nozzle is secured
properly. Check to see that the nozzle is secure.
To disconnect a nozzle from the trigger handle once the
cleaning job is complete:

Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.
 Engage the lock out on the trigger handle by pushing up
on the lock out until it clicks into the slot.

Pull back and hold the quick-connect collar.

Remove the nozzle by pulling it from the quick-connect
collar. Place nozzle in the nozzle storage area on the top
of the machine.
USING THE HIGH PRESSURE HOSE
The high pressure hose features an outer covering that pro-
vides strength to the hose. If the outer covering becomes
damaged, the hose must be replaced immediately.
Do not
use a high pressure hose if the outer covering is damaged.
To prevent damage to the outer covering:
 Inspect the hose before every use.

Fully unwrap and straighten hose before use.
 Do not allow the high pressure hose to be kinked.

Keep hose away from hot surfaces and sharp edges.

Do not pull unit by high pressure hose.

Do not allow hose to be crushed or wrapped around
objects.
WASHING WITH DETERGENT
See Figure 14.
As sold, this unit is designed for use with “downstream” pres-
sure washer detergents. To convert for use with “upstream”
detergents, contact an authorized customer service center
for more information.
USE ONLy DETERGENTS DESIGNED FOR PRESSURE
WASHERS;
Do not use household detergents, acids,
alkalines, bleaches, solvents, flammable material, or
industrial grade solutions, which can damage the pump.
Many detergents may require mixing prior to use. Prepare
cleaning solution as instructed on the solution bottle. Always
test in an inconspicuous area before beginning.

Remove the cap from the detergent tank and pour pres-
sure washer detergent in the tank. Replace cap on tank.
NOTE: The machine setting of this unit is 20:1, which usu-
ally allows the use of 1 gallon pressure washer detergent
without further dilution. Check your detergent instructions
to be sure additional dilution is not necessary.
 Install the black soap nozzle on the spray wand.

Squeeze the trigger and wait approximately 5 seconds
for the detergent to appear.
 Spray the detergent on a dry surface using long, even,
overlapping strokes. To prevent streaking, do not allow
detergent to dry on the surface.
Before shutting off the engine:
 Fill the detergent tank with clean water.

Spray the clear water through the spray wand until the
tank is empty.

If any soap remains in the spray, repeat with a second
tank of clean water.

Shut off the engine.
NOTE:
Shutting
OFF ( O )
the engine will not relieve pressure
in the system.
Pull trigger to release water pressure.
RINSING WITH THE PRESSURE WASHER

Turn off the pressure washer and shut off the water
supply.
Pull trigger to release water pressure.

Engage the lock out on the trigger handle by pushing up
on the lock out until it clicks into the slot.
 Remove the nozzle by placing hand over nozzle then
pulling back the quick-connect collar. Place nozzle in the
nozzle storage area on the top of the machine.

Select the right nozzle for the job. See the chart on the
previous page for selecting the appropriate nozzle.

Start at the top of the area to be rinsed and work down,
overlapping the strokes.
OPERATION