6
SPACE WALKER -
ITEM CODE: BH65-A
.
Instruction Manual
6. Insert the 90 degree bend down through
the hole in the servo arm. Install one nylon
snap keeper over the wire to secure it to the
arm. Install the servo arm retaining screw and
remove the masking tape from the aileron.
Repeat the procedure for the other wing
half
.
1. Working with the aileron linkage for now,
thread one clevis onto one of the threaded
wires.
INSTALLING THE AILERON
LINKAGES.
2. Attach the clevis to the outer hole in the
control horn.
3. Plug the aileron servo into the receiver
and center the servo. Install the servo arm onto
the servo. The servo arm should be perpen-
dicular to the servo and point toward the mid-
dle of the wing.
4. Locate one nylon servo arm, and using
wire cutters,remove all but one of the arms.
Using a 2mm drill bit, enlarge the third hole
out from the center of the arm to accommo-
date the aileron pushrod wire.
5. Using pliers, carefully make a 90 degree
bend down at the mark made. Cut off the ex-
cess wire, leaving about 4mm beyond the
bend.
M2 lock nut.
M2 clevis.
Snap keeper.
INSTALLING THE ENGINE MOUNT.
THERE ARE TWO OPTIONS:
1. ELECTRIC MOTOR
2. ENGINE MOUNT.
1.
OPTION 1: ELECTRIC MOTOR.
3 x 15mm
3x 15mm
Bend and cut after.
Bottom side
Cut.