20
SPACE WALKER -
ITEM CODE: BH65-A
.
Instruction Manual
3. Mark the shape of the vertical on the left
and right side on the rudder using a felt-tip
pen.
2. Slide the rudder into the fuselage as
same as picture below.
4. Now, remove the rudder and using a
modeling knife, carefully cut just inside the
marked lines and remove the film of the rud-
der. Just as you did with the horizontal stabi-
lizer, make sure you only press hard enough
to cut the film, not the balsa rudder.
5. Put the vertical stabilizer back in place.
Using a triangle, check to ensure that the
vertical stabilizer is aligned 90 degree to the
horizontal stabilizer.
6) When you are sure that everything is a
aligned correctly, mix up a generous amount
of 30 minute epoxy. Apply a thin layer to the
slot in the mounting platform and to the verti-
cal stabilizer mounting area. Apply epoxy to
the lower rudder hinge. Set the stabilizer in
place and re-align. Double check all of your
measurements once more before the epoxy
cures. Remove any excess epoxy using a
paper towel and rubbing alcohol and hold the
stabilizer in place with T-pins or masking tape.
Allow the epoxy to fully cure before proceed-
ing.
1) Using a modeling knife, remove the cov-
ering from the top of the fuselage and the cov-
ering from over the precut hinge slot cut into
the lower rear portion of the fuselage This slot
accepts the lower vertical.
Remove
covering
Hinge slot
Mark line.
Remove
covering
90º
Vertical
Stabilizer.
Horizontal
Stabilizer.