4
RENEGADE -
ITEM CODE:BH66-A
Instruction Manual
2. Using a modeling knife, remove the cov-
ering servo tray.
3. Drill 1,5mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo. Install servo into ai-
leron servo tray as same as picture below.
4. Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out.
When you have pulled the servo lead out, re-
move the masking tape and the servo lead
from the thread.
5. Instal servo tray with aileron servo into
the wing as same as picture below.
Assemble then apply drops of thin
C/A to center of hinge,on both sides.
Bottom side
Secure
Thread
Temporary pin to
keep hinge centered.
Remove covering
Servo tray
Electric wire
