18
RENEGADE -
ITEM CODE:BH66-A
Instruction Manual
5. Slide the vertical stabilizer back in
place. Using a triangle, check to ensure that
the vertical stabilizer is aligned 90º to the hori-
zontal stabilizer.
90º
Vertical
Stabilizer.
Horizontal
Stabilizer.
Temporary pin to
keep hinge centered.
Assemble then apply drops of thin
C/A to center of hinge,on both sides.
1. Slide the rudder into the fuselage as
same as picture below.
2. While holding the vertical stabilizer
firmly in place, use a pen and draw a line on
each side of the vertical stabilizer where it
meets the top of the fuselage.
3. Remove the stabilizer. Using a model-
ing knife, remove the covering from below the
lines you drew. Also remove the covering from
the bottom edge of the stabilizer.
Remove covering
Rudder servo.
See picture below:
Cut the covering
away from the slot.
VERTICAL INSTALLATION.
Control clasp.
Mark line
