5
Impulse 100TD
- Item code: BH 121
.
Instruction Manual
2. Using a modeling knife, remove the cov-
ering servo tray.
Assemble then apply drops of thin
C/A to center of hinge,on both sides.
Servo tray.
Remove covering
3. Drill 1,5mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo. Install servo into ai-
leron servo tray as same as picture below.
4. Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out.
When you have pulled the servo lead out, re-
move the masking tape and the servo lead
from the thread.
Secure.
Thread.
Electric
wire.
