22
Impulse 100TD
- Item code: BH 121
.
Instruction Manual
1. Set the tail wheel assembly in place
on the plywood plate. The pivot point of the
tail wheel wire should be even with the rud-
der hinge line and the tail wheel bracket should
be centered on the plywood plate.
MOUNTING THE TAIL WHEEL
BRACKET.
2. Using a pen, mark the locations of the
two mounting screws. Remove the tail wheel
bracket and drill 1mm pilot holes at the loca-
tions marked.
3 x 12mm
Drill a hole
2mm diameter.
Elevator
pushrod.
R u d d e r
pushrod.
Bottom side.
PARTS REQUIRED
MAIN GEAR INSTALATION.
1) Assemble and mounting the wheel pants
as shown in the following pictures.
5x 40mm
5x 40mm
Secure.
