P47-THUNDERBOLT
.
Item code: BH36-B.
Instruction Manual
12
When you are sure that everything is aligned
correctly, mix up a generous amount of 30 minute
epoxy. Apply a thin layer to the top and bottom of the
stabilizer mounting area and to the stabilizer mounting
platform sides in the fuselage. Slide the stabilizer in
place and re-align. Double check all of your measure-
ments one more time before the epoxy cures. Remove
any excess epoxy using a paper towel and rubbing
alcohol and hold the stabilizer in place with T-pins or
masking tape.
Elevator control horn
Drill a hole
1.5 mm
Top side
C/A glue.
After the epoxy has fully cured, remove the masking
tape or T-pins used to hold the stabilizer in place and
carefully inspect the glue joints. Use more epoxy to fill
in any gaps that may exits that were not filled previ
-
ously and clean up the excess using a paper towel and
rubbing alcohol.
2. ELEVATOR PUSHROD INSTALLATION
1)
Using pliers, carefully make a 90 degree bend
down at the mark made. Cut off the excess wire, leaving
about 6mm beyond the blend.
2)
Insert the 90 degree bend down through the
hole in the servo arm. Install one nylon snap keeper
over the wire to secure it to the arm. Install the servo
arm retaining screw.
VIII. THE TAIL WHEEL BRACkET,
RUDDER INSTALLATION
Rudder install as same as the way of aileron.
A+B Epoxy glue
Elevator servo
Cut.
Bend
Elevator pushrod
Secure.
Snap keeper
Secure.
Flaslink
Pushrod wire
servo arm
M2 Lock nut
M2
Elevator pushrod
Bottom side.
Silicone Tube
