INSTALLING THE AILERONS AND FLAPS.
B
Aileron
Bottom view
Flaps
Flaps
B
INSTALLING THE AILERONS AND FLAPS SERVOS.
1.
Install the rubber grommets and brass eyelets
onto the aileron servos.
2.
Using a modeling knife, remove the covering
from over the pre-cut servo arm exit hole on the
aileron servo tray / hatch. This hole will allow the
servo arm to pass through when installing the aileron
pushrods.
3.
Place the servo into the servo tray. Center the
servo within the tray and drill 1.5mm pilot holes
through the block of wood for each of the four
mounting screws provided with the servo.
4.
Using the thread as a guide and using masking
tape, tape the servo lead to the end of the thread:
carefully pull the thread out. When you have pulled
the servo lead out, remove the masking tape and the
servo lead from the thread.
5.
Place the servo into the servo tray/ hatch into the
servo box on the bottom of the wing and drill 1.5mm
pilot holes through the tray and servo box for each of
the four mounting screws. Secure the servo tray in
place using the mounting screws provided.
6
. Repeat step # 2 - # 5 to install the second aileron
servo in the opposite wing half.
Instruction manual
JUNKERS JU87- B2 STUKA Item code: BH169
6
