BALANCING
1)
It is critical that your airplane be balanced
correctly. Improper balance will cause your plane to
lose control and crash.
THE CENTER OF GRAVITY IS LOCATED
130MM
BACK FROM THE LEADING EDGE OF THE WING.
2)
Mount the wing to the fuselage. Using a couple of
pieces of masking tape, place them on the top side of
the wing
130mm
back from the leading edge, at the
fuselage sides.
3)
Turn the airplane upside down. Place your fingers
on the masking tape and carefully lift the plane.
4)
AT THE FUSELAGE. BALANCE A PLANE UPSIDE
DOWN WITH THE FUEL TANK EMPTY.
If the nose of the plane falls, the plane is nose
heavy. To correct this first move the battery pack
further back in the fuselage. If this is not possible or
does not correct it, stick small amounts of lead
weight on the fuselage under the horizontal
stabilizer. If the tail of the plane falls, the plane is tail
heavy. To correct this, move the battery and receiver
forward or if this is not possible, stick weight into the
firewall. When balanced correctly, the airplane
should sit level or slightly nose down when you lift it
up with your fingers.
LATERAL BALANCE
After you have balanced a plane on the C.G.
You should laterally balance it. Doing this will
help the airplane track straighter.
1)
Turn the airplane upside down. Attach one loop
of heavy string to the engine crankshaft and one to
the tail wheel wire. With the wings level, carefully
lift the airplane by the string. This may require two
people to make it easier.
1)
We highly recommend setting up a plane using the
control throws listed.
2)
The control throws should be measured at the
widest point of each control surface.
3)
Check to be sure the control surfaces move in the
correct directions.
CONTROL THROWS
?
Aileron: 12 m
m up
mm down
?
Elevator:
mm up
mm down
?
Rudder:
mm right
mm left
12
10
10
30
30
?
Flap: 20mm
Low rate:
PRE-FLIGHT CHECK
1)
Completely charge your transmitter and receiver
batteries before your first day of flying.
2)
Check every bolt and every glue joint in your
plane to ensure that everything is tight and well
bonded.
3)
Double check the balance of the airplane.
4)
Check the control surface.
5)
Check the receiver antenna. It should be fully
extended and not coiled up inside the fuselage.
6)
Properly balance the propeller.
2)
If one side of the wing fall, that side is heavier
than the opposite. Add small amounts of lead
weight to the bottom side of the lighter wing half's
wing tip. Follow this procedure until the wing stays
level when you lift the airplane.
Instruction manual
JUNKERS JU87- B2 STUKA Item code: BH169
12mm
Aileron control
12mm
10mm
10mm
Elevator
30mm
30mm
Rudder control
20mm
Flap
?
Aileron: 16 m
m up 16 mm down
?
Elevator: 12 mm up 12 mm down
?
Rudder: 35 mm right 35 mm left
?
Flap: 25mm
High rate:
30
130mm
C G
