Instruction manual
JUNKERS JU87- B2 STUKA Item code: BH169
3 x 12mm Screw
- - - - 4
MOUNTING THE COWL
1)
Remove the muffler and needle valve
assembly from the engine. Slide the
fiberglass cowl over the engine.
2)
Measure and mark the locations to be cut
out for engine head clearance, needle valve,
muffler. Remove the cowl and make these
cutouts using a rotary tool with a cutting disc
and a rotary sanding drum attachment.
3)
Slide the cowl back into place. Align the
front of the cowl with the crankshaft of the
engine. The front of the cowl should be
positioned so the crankshaft is in the middle
of the precut opening. Hold the cowl firmly in
place using several pieces of masking tape.
4)
While holding the cowl firmly in position,
drill four 1,6mm pilot holes through both the
cowl and the side edges of the firewall.
5)
Using a 3mm drill bit, enlarge the four
holes in the cowling.
Enlarging the holes through the cowl will
prevent the fiberglass from splitting when the
mounting screws are installed.
6)
Slide the cowl back over the engine and secure
it in place using four screws.
7)
Install the muffler. Connect the fuel and pressure
lines to the carburator, muffler and fuel filler valve.
Tighten the screws completely.
3x12mm
Screw
2mm
Cowl area cutout
for muffler
Cowl area cutout
for engine head.
161mm
1
19mm
333mm
231mm
16
3x12mm
Screw
2mm
5mm
