4
RADIAL ROCKET Item code: BH155
.
Instruction Manual
1. INSTALLINg THE AILERONS
I. AILERON
Assemble then apply drops of thin
C/A to center of hinge,on both sides.
Temporary pin to
keep hinge centered.
Test fit the ailerons to the wing with the hinges. If the
hinges don’t remain centered, stick a pin through the
middle of the hinge to hold it in position.
See pictures below:
2. INSTALLINg THE AILERON SERVOS
1)
Install the rubber grommets and brass
eyelets on to the aileron servos.
2)
Using a modeling knife, remove the
covering from over the pre-cut servo arm exit hole on
the aileron servo tray / hatch. This hole will allow the
servo arm to pass through when installing the aileron
pushrods.
Servo tray
Remove the covering
Aileron
Flap
Bottom side.
REPLACEMENT SMALL PARTS
3 x 12mm
7
5
4x25mm
3
3x15mm
4x60mm
6
2
4
3x25mm
2x10mm
3x12mm
3x15mm
3x10mm
1. Wire gear.
2. Wheels.
3. Plastic - engine mount.
4. Wood - motor mount.
5. Spinner.
6. Fuel Tank
6a. Clunk.
6b. Stopper (three line).
7. Tail gear set.
1
1
6b
6a
M2