PIPER CUB.
INSTRUCTION MANUAL
4
3. Drill 1,5mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo. Install servo into aileron
servo tray as same as picture below.
2. Using a modeling knife, remove the cov-
ering servo tray.
Servo tray
5. Instal servo tray with aileron servo into
the wing as same as picture below.
Thread.
Electric wire.
Servo tray.
Wing.
2x10mm.
4. Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out.
When you have pulled the servo lead out,
remove the masking tape and the servo lead
from the thread.
