Black Horse Model A6M ZERO, Instruction Manual Book

Page: 9 / 51

INSTRUCTION MANUAL A6M ZERO Item code: BH180
9
INSTALLING THE AILERONS AND FLAPS SERVOS.
1.
Install the rubber grommets and
brass eyelets onto the aileron servos.
2.
Using a modeling knife, remove the
covering from over the pre-cut servo arm
exit hole on the aileron servo tray / hatch.
This hole will allow the servo arm to pass
through when installing the aileron
pushrods.
3.
Place the servo into the servo tray. Center the servo within
the tray and drill 1.5mm pilot holes through the block of wood for
each of the four mounting screws provided with the servo.
4.
Using the thread as a guide and using masking tape, tape
the servo lead to the end of the thread: carefully pull the thread
out. When you have pulled the servo lead out, remove the
masking tape and the servo lead from the thread.
5.
Place the servo into the servo tray/ hatch into the servo box
on the bottom of the wing and drill 1.5mm pilot holes through the
tray and servo box for each of the four mounting screws. Secure
the servo tray in place using the mounting screws provided.
6
. Repeat step # 2 - # 5 to install the second aileron servo in the
opposite wing half.
Cut off shaded portion
carefully.
Assemble left and right
sides the same way.
Must be purchased
separately!
Pay close attention here.
Drill holes using the stated.
(in this case 1.5mm ).
1.5mm
The number of times
the same way Assembly
(in this case twice).
4
2x10mm Tp Screw
- - - - 16
- - - - 4
- - - - 1 - - - - 1
- - - - 4
- - - - 8
- - - - 2
- - - - 2
- - - - - - - 6
- - - - 2
- - - - 8
3x12mm Cap Screw
3x15mm Tp Screw
3mm Hex Nut
3mm Flat Screw
Horn
Ball link
Plastic
2.6x80mm Push rod
- - - - 2
2.6x100mm Push rod
Bottom View
For Aileron servo
For Flap servo