21
SPEED AIR-40 _
Item code:BH08.
Instruction Manual.
6) When you are sure that everything is a
aligned correctly, mix up a generous amount
of 30 minute epoxy. Apply a thin layer to the
slot in the mounting platform and to the verti-
cal stabilizer mounting area. Apply epoxy to
the lower rudder hinge. Set the stabilizer in
place and re-align. Double check all of your
measurements once more before the epoxy
cures. Remove any excess epoxy using a
paper towel and rubbing alcohol and hold the
stabilizer in place with T-pins or masking tape.
Allow the epoxy to fully cure before proceed-
ing.
Epoxy glue.
C/A glue.
C/A glue.
1) Locate the two nylon control horns, two
nylon control horn backplates and four M2 x
12mm machine screws.
2) Position the rudder horn on the bottom
side of rudder.
3) Using a 1.5mm drill bit and the control
horns as a guide, drill the mounting holes
through the rudder halves.
RUDDER CONTROL HORN
AND PUSHROD INSTALLATION.
2 x 12mm.
Mark point and
drill 1.5mm
