11
SPEED AIR-40 _
Item code:BH08.
Instruction Manual.
Locate the long piece of wire used for the
throttle pushrod. One end of the wire has been
pre-bend in to a “Z” bend at the factory. This
“Z” bend should be inserted into the throttle
arm of the engine when the engine is fitted onto
the engine mount. Fit the engine to the engine
mount using the screws provided.
INSTALLING THE ENGINE.
Mark point.
Drill a hole 2.5mm
diameter
Secure.
Throttle wire.
Left side.
INSTALLING THE STOPPER ASSEMBLY
1) The stopper has been pre-assembled
at the factory.
2) Using a modeling knife, cut one length of
silicon fuel line (the length of silicon fuel line is
calculated by how the weighted clunk should
rest about 8mm away from the rear of the tank
and move freely inside the tank). Connect one
end of the line to the weighted clunk and the
other end to the nylon pick up tube in the stop-
per.
FUEL TANK.
3x 20mm
