PC-9 Item code: BH151
.
Instruction Manual
5
1)
Install the rubber grommets and brass
eyelets on to the aileron servos.
2)
Using a modeling knife, remove the
covering from over the pre-cut servo arm exit hole on
the aileron servo tray / hatch. This hole will allow the
servo arm to pass through when installing the aileron
pushrods.
1. INSTALLING THE AILERON SERVOS
I. AILERON
Flap
Aileron
Bottom side.
Drill a hole
1.5mm
Servo tray
Remove the covering
Secure
3)
Using the thread as a guide and using mask-
ing tape, tape the servo lead to the end of the thread:
carefully pull the thread out. When you have pulled the
servo lead out, remove the masking tape and the servo
lead from the thread.
4)
Place the servo into the servo tray. Center
the servo within the tray and drill 1.5mm pilot holes
through the block of wood for each of the four mount-
ing screws provided with the servo.
Drill a hole
1.5mm
2x10mm
Secure
5)
Repeat the procedure to install the
aileron servos in the opposite wing half
.
2. INSTALLING THE AILERON CONTROL HORN
1)
Remove the covering from the slot on the bot-
tom of the aileron.
2)
Insert the control horn into the slot and secure
it by A+B Epoxy glue.
Electric wire
