7
ENGLISH
(Original instructions)
Chargers
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate.
Warning!
Never attempt to replace the
charger unit with a regular mains plug.
u
Use your BLACK+DECKER charger
only to charge the battery in the
appliance with which it was supplied.
Other batteries could burst, causing
personal injury and damage.
u
Never attempt to charge non-
rechargeable batteries.
u
If the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
u
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/battery must be
placed in a well ventilated area when
charging.
Electrical safety
Symbols on the charger
Read all of this manual carefully before using the
appliance.
This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
The charging base is intended for indoor use
only.
Labels on appliance
The following symbols appear on this appliance along with the
date code
Read all of this manual carefully before
using the appliance
S010Q 23
SSC-250040EU
BSV2020GW use charger SSC-250040EU
Features
This tool includes some or all of the following features.
1. On/Off button
2. 3 speed power switch
2a. Beater bar activation button
3. State of charge indicator
3a. Filter sense
4. 20V Battery
5. 20V cup charger and charging station
6. Lift away dust canister
with filter agitator
7. Dust canister
door
8. Floor head
9. Extension tube
10. 2 in 1 Accesssory tool
11. Crevice tool
(available to order throughservice
department)
12. Accessory storage clip
13. Wide mouth dust brush (available available to order
through service department)
14. Charge port
Charging a Battery
BLACK+DECKER chargers are designed to charge
BLACK+DECKER battery packs.
Note:
To ensure maximum performance and life of lithium
ion battery packs:
u
Charge the battery pack fully before first use.
u
Recharge discharged batteries as soon as possible
after every use.
u
Do not discharge batteries fully.
The supplied charger offers three possible ways to charge
your battery.
1.
Standard cup charging only
2.
Wall mounted cup charging
3.
Wall mounted suspended charging
1. Standard cup charging (Fig. A)
u
Plug the charger (5) into an appropriate outlet before
inserting the battery pack (4).
u
Insert the battery pack into the cup charger.
u
When using the the cup charger a green LED will flash
indicating that the battery is being charged.
u
The completion of charge is indicated by the green LED
remaining on continuously. The pack is fully charged
and may be used at this time or left on the charger.
u
The cup charger can be inserted into the charging station
(5a) as shown in figure A.
