Black+Decker BDC8, Original Instruction

Page: 4 / 24

4
ENGLISH
(Original instructions)
6. The manufacturer cannot be held liable
for damage resulting from improper
usage or incorrect operation.
Caution! If you wish to cool
medicines, please check if the
cooling capacity of the device is
suitable for the medicine in question.
Features
1. Cooling device
2. Plastic lid
3. Connection cable for 12V DC
4. Bag
5.
Ventilation slots
6. Control panel
7. Shoulder strap (Not shown)
General safety rules
Warning! Do not switch from cold to
hot or from hot to cold. The instant
100 degree change can damage the
unit. You need to turn off the unit,
wait 10 minutes and then slide the main
switch to the desired function heat or cool.
Warning! Read carefully and
understand all assembly and
operation instructions before
operating. Failure to follow the safety rules
and other basic safety precautions may
result in serious personal injury.
Caution! Do not allow persons to
operate or assemble this cooler and
warmer until they have read this
manual and have developed a thorough
understanding of how the cooler and
warmer works.
Warning!
The warnings, cautions,
and instructions discussed in this
instruction manual cannot cover all
possible conditions or situations that could
occur. It must be understood by the
operator that common sense and caution
are factors which cannot be built into this
product, but must be supplied by the
operator.
Electric safety instructions for
power supply
In order to comply with the safety
requirements set forth in several
international publications, the following
measures must be followed when using this
unit:
1. The maximum room temperature around
the power supply must not exceed the
one indicated on its label.
2. When connecting the unit to the electric
supply and to the equipment,
respectively, you must check if the
voltage is the same indicated in the unit.
3.
The consumption of the equipment
connected to the source output must not
exceed the one indicated in the unit.
4. This product can be used for outdoor, just
make sure not make it wet.
5. If the power supply cable is damaged, it
must be fixed by the supplier, by its
representative or by qualified personnel
to avoid danger.
6. If the unit was hit and it is noticed any
damage in the protection cover or
failures, the unit must not be used and
must be fixed exclusively by technically
qualified personnel assigned by the
product importer and/or legal
representative.
7.
The equipment must be connected to a
visible and easy access socket.
8. This product is not a toy.
It is not
intended for use by children under 8
years.
Important safety precautions
Note:
There is a replaceable 10A to 6.3A.
Replace a blown fuse by gently unscrewing
the tip of the lighter plug and inserting in a
new one of comparable Amperes rating. Do
Not replace fuse with a higher amp rated
fuse.
• Do not
immerse the cooler/warmer 12V
plug in water.
• Do not
insert foreign objects into the
cooler/warmer vent openings.The
ventilation openings should not be
covered at any time while the
cooler/warmer is operating.
• Do not use the cooler/warmer in the open
air when it is raining or snowing; it is not
designed to be waterproof.