12
Standalone G-Converter
SALES: 0118 965 5100
The G-Converters support one input flag and two output flags. It is up to the user which of
the signals is to be implemented. RTS would normally be the definition for Flag 1 I/P
(although is does not have to be) as this is the only I/P called up by the V.35 spec.
The two output flags, Flag 2 O/P and Flag 3 O/P can be assigned to either CTS, DSR or
DCD, the choice is at the discretion of the user.
The connector pin out for the V.35 interface is given in Appendix H and a suggested stub
cable converter to 34 pin MRAC is given in
Appendix I – V.35 Stub Cable
.
Configuration Of V.35 Control Flags
When the V.35 interface is selected the FLAG 1 O/P and FLAG 2 O/P can be individually
controlled. Four choices are available to the user.
Selection is made via switch settings. Refer to the location diagram in
Appendix D -
Location Of Switches and Links
.
SW4, 4
SW4, 5
FUNCTION OF O/P
FLAG 1
OFF
OFF
FLAG 1 O/P follows
FLAG 3 I/P
OFF
ON
FLAG 1 O/P = active
ON
OFF
FLAG 1 O/P = inactive
ON
ON
FLAG 1 O/P follows
carrier
SW5, 2
SW5, 3
FUNCTION OF FLAG 2
O/P
OFF
OFF
FLAG 2 O/P follows
FLAG 3 I/P
OFF
ON
FLAG 2 O/P = active
ON
OFF
FLAG 2 O/P = inactive
ON
ON
FLAG 2 O/P follows
carrier
