10
SHM-B PARALLEL-T, SHM-B PARALLEL -R
Remove the SHM-B card from the case or rack, exposing the terminal connector
on the card. (For instructions on opening the standalone unit’s case, see step 2 in
Section 3.6
.) Strip
1
⁄
8
to
3
⁄
16
inch of the insulation from the end of all four of the
cable wires. Insert the wires into the terminal block and tighten the screw
terminals. Depending on your application, connect the terminals on the
transmitter to the terminals on the receiver as shown in Figure 3-1, 3-2, or 3-3.
Figure 3-1. Parallel-to-Parallel Installation
Figure 3-2. Serial-to-Parallel Installation
When you have made the connections, thread the nylon cable tie (provided)
through the tie-down holes in the card and around the wires. Pull tightly until the
cable tie has secured the wires to the card. Remove the excess tie.
SHM-B
TRANSMITTER
SHM-B PARALLEL-R
RECEIVER
SHM-B PARALLEL-T
TRANSMITTER
SHM-B PARALLEL-R
RECEIVER
