PORT command
The PORT command sets the current port for management or configuration. Information about current
active port is display in prompt.
NTU_CM_S09_P1>PORT 1
NTU_CM_S09_P1>PORT 2
NTU_CM_S09_P2>
OPERATE command (only for MDS931C-2, MDS931AE-2 models)
The OPERATE command depend the 2 Mbits ( Bridge) or 4 Mbits (Transparent) operation mode. When
the value will be changed, it is necessary to sets MASTER, ADAPTIVE LINERATE parameters every
ports.
NTU_CM_S09_P2>OPERATE 1
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
xDSL
Line Rate,kbit/s : 1296
Master/Slave : Master
Adaptive mode : ON
Operation mode : Transparent
Ethernet
Speed : 100
Duplex mode : FULL
Telnet mode : ON
IP Address : 10.7.1.1
Subnet mask : 255.0.0.0
Default gateway : 10.27.66.1
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
01:05:06 system reset
TELNET command
The TELNET command enables or disables of TCP/IP packets. You can manage only local modem via
telnet session.
NTU_CM_S09_P1>TELNET OFF
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
xDSL
Line Rate,kbit/s : 1296
Master/Slave : Master
Adaptive mode : ON
Operation mode : Transparent
Ethernet
Speed : 100
Duplex mode : FULL
Telnet mode : OFF
IP Address : 10.7.1.1
Subnet mask : 255.0.0.0
Default gateway : 10.27.66.1
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Date 21.10.03
page 24 of 29
00:11:43 system reset
