ALARM command
The ALARM command informs the user about urgent and non-urgent alarms. Upon entering the <C>
parameter, the updating of the information on the screen will occur automatically with the interval of 5…20
seconds according to the parameter set by the TRACETIME command:
Alarm Status
Urgent: LossSync - ON HiEPR - OFF
Not-urgent: Link - OFF LoEPR - OFF SQ - OFF
NTU_FMM_S09_P1>
Configuration management submenu
Upon activation of the configuration management submenu the following message will be displayed.
01:47:50 Configuration management activated
Enter <M> to return to MAIN, or <H> for HELP information
NTU_CM_S09_P1>
Press <H> to see all available commands with their brief description.
NTU_CM_S09_P1>H
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
CONFIG Display local configuration
RESET System Reset
TELNET ON|OFF Set telnet mode to ON/OFF
IP XXX.XXX.XXX.XXX Set IP Address for this card (where XXX = 0..255)
NETMASK XXX.XXX.XXX.XXX Set Network Mask for this card (where XXX = 0..255)
GATEWAY XXX.XXX.XXX.XXX Set Default Gateway for this card (where XXX = 0..255)
MASTER ON|OFF Set xDSL master/slave mode (similar to CO/RT)
LINERATE [1..16] Select line rate
ADAPTIVE ON|OFF Set adaptive mode to ON/OFF ( only for slave mode)
DEFAULT [0..1] Set default configuration
ESPEED [AUTO|10|100] Set speed of Ethernet port
EMODE [AUTO|HALF|FULL] Set Duplex mode of Ethernet port
TRACETIME [5..20] Change trace time (5..20 seconds)
PORT [1..2] Change port number (1..2)
OPERATE [1..2] Change operation mode (1..2)
M(AIN) Return to main menu
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
NTU_CM_S09_P1>
TRACETIME command
The TRACETIME command allows the user to change the time interval of updating the information on the
screen (5…20 seconds):
NTU_CM_S09_P1>TRACETIME 10
Date 21.10.03
page 19 of 29
