724-746-5500 | blackbox.com
Page 15
3. Next, you will see the extender’s log-in page. The default name and password are “admin” and “password,” respectively. Enter
them and then click “Login.”
NOTE: Preconfigured units will have the same default name and password: default name: admin and default password:
password.
Figure 4-3. Login screen.
NOTE: Since the Wireless P-T-P Ethernet Extender covers AP mode, wireless client mode, bridge mode, and AP repeater mode,
follow the relevant steps below to set each mode after successful log-in.
4.1 AP Mode
1. Choose “Wireless > Basic Settings.” You”ll see the screen in Figure 4-4. The default is AP mode. Set the parameters to optimize
your application, or leave them as the default. Click “Apply” to save the parameters.
NOTE: For better coverage of the AP, you may also use an external antenna. If so, remember to change the antenna setting from
“Internal (8 dBi)” to “External (N-Type)” after you install your external antenna.
CAUTION: Make sure you choose “External (N-Type)” only when you have installed the external antenna; otherwise, the Wireless
P-T-P Ethernet Extender might be damaged.
Chapter 4: Configuration Steps
Summary of Contents for LWE100A
Page 22: ...724 746 5500 blackbox com Page 22 NOTES ...
Page 23: ...Page 23 NOTES ...
