724-746-5500 | blackbox.com
Page 11
Chapter 3: Installation
3. Installation
3.1 DIN Rail Mounting
The DIN-Rail clip already attached on the rear side of the switch supports an EN 50022 standard DIN Rail as shown in Figure 3-1.
Spring
DIN rail
DIN rail clipper
1.35" (3.5 cm)
1.063" (2.7 cm)
0.295"
(0.75 cm)
Figure 3-1. DIN rail mounting.
Follow the steps below to mount the switch on the DIN-Rail track.
1. Insert the upper end of the DIN-Rail clip into the back of the DIN-Rail track from its upper side.
2. Lightly push the bottom of the DIN-Rail clip into the track.
3. Check if the DIN-Rail clip is tightly attached to the track.
4. To remove the switch from the track, reverse the steps 1–3 above.
