11
3. Installation
3.1 Before You Begin
Before you can install the Remote Port USB 2.0 -CAT5, you need to prepare your site.
1. Determine where the computer is to be located and set up the computer.
2. Determine where you want to locate the USB device(s).
3. If you are using surface cabling, the Remote Port USB 2.0 -CAT5 supports a
maximum distance of 100m.
OR
If you are using premise cabling, ensure CAT5 cabling is installed between the two
locations, with CAT5 information outlets located near both the computer and the USB
device(s).
3.2 Installing the Local Unit
1. Place the Local Unit near the computer.
2. Plug the USB Type A connector on the Local Unit into a USB port on the
computer.
NOTE
Use only the AC adapters supplied with the Remote Port USB 2.0 -CAT5. Use of substitute adapters may cause permanent
damage to the system and will void the warranty.
3.3 Installing the Remote Unit
1. Place the Remote Unit near the USB device(s).
2. Plug the power adapter into a suitable AC outlet.
3. Connect the power adapter to the Remote Unit.
NOTE
Use only the AC adapters supplied with the Remote Port USB 2.0 -CAT5. Use of substitute adapters may cause permanent
damage to the system and will void the warranty.
CHAPTER 3: Installation
