17
CHAPTER 4: Operation
4. Operation
4.1 Using with a Headset
1. Make sure the
headset/handset selector on
top of the base is in the
headset position. Put on the
headset, pick up the
handset, and answer the
phone or make a call.
2. To end the call, put the
handset down.
3. When you answer or make a
call using the headset, the
on-line indicator on the
base starts flashing. This
means the base is
communicating with the
remote (Figure 4-1).
Figure 4-1. On-Line Indicator Flashing.
4. To move away from your
desk during the call, remove
the remote from the base
and clip it to your belt or
put it in your pocket. You
can now move freely up to
200 feet away from the base.
If you move out of
transmission range, you will
hear a double beep in your
headset every 10 seconds.
4.2 Using with a Handset
1. Make sure the headset/
handset selector on top of
the base is in the handset
position.
2. Pick up the handset to
answer the phone or make a
call as usual.
3. To end the call, put down
the handset.
4.3 Using the Pocket and Belt Clips
1. The remote ships with the
pocket clip installed. To use,
slide the wire clip behind
the fabric of your pocket.
2. To use the belt clip, first
remove the wire pocket clip.
While holding the remote
face down, gently pull the
wire clip from both sides of
the unit (Figure 4-2).
