Page 25
EC24U3032
877-877-2269 | blackbox.com
Chapter 3: Changing the Cabinet’s Configuration
3.6 Adjusting the Rails
Mounting Rails
The vertical mounting rails are installed with all standard frames. You can configure the 30" wide enclosure to 23" EIA mounting
with an optional bracket set. Extra sets of both square hole rails (M6) and tapped #10-32 rails are available as accessories.
(See page 15).
Figure 3-8. Adjusting the vertical mounting rails.
Rails are attached using a sliding nut and
1
⁄
4
-20 hex head bolt. Loosen both top and bottom bolts, using a
3
⁄
8
" socket set, then
adjust the rails front to back using the alignment guide notches shown in Figure 3-8. Rackmount units (RU) are marked on rails
for easy equipment mounting. Round cable passthrough and vertical and horizontal cable tie-down slots are provided on side of
rails.
3.7 Bottom Panel
Figure 3-9 shows the cabinet’s bottom panel.
Figure 3-9. Bottom panel.
Alignment guide
notch
