SERVICE SETUP
29
Reset of the internal DDC Table to Default-Values
If you have loaded several DDC Configurations and got no satisfying result, you can
restore the original (default) DDC Table. To do this, please proceed the followin steps:
•
Switch off the Local Unit
•
Open the Local Unit like described above
•
Unplug Jumper JP1 (Jumpers JP1 and JP2 are now open - Dualhead devices: jumper
setting on BOTH PCB’s!)
•
Switch on the Local Unit
•
After a successful reprogramming of the DDC EPROM, the ‚Video-OK’ LED at the
Local Unit is blinking rapidly for approx. 1 second
•
Switch off the Local Unit
•
Replug Jumper JP1 (Dualhead devices: jumper setting on BOTH PCB’s!)
•
Close the Local Unit like described above
•
Switch on the Local Unit
•
Done
Selection of Color depth
You can select, whether 18Bit colors (=256K colors) are transmitted (default) or 21Bit colors
(=2M colors). Low color depth enhances the count of frames, transmitted per second, high
color depth gives smooth color grades. Please select to you choice the better mode.
Color depth
JP3
18Bit (default)
21Bit
