6
soil is wet - for electrical safety and to prevent
clogging of the tines. If you must cultivate
under conditions that cause the tines to
become clogged, release trigger, wait for tines
to come to complete stop! UNPLUG! Remove
clogged material with a stick or screwdriver.
Continuing to operate the tool in a clogged
condition will seriously overload the motor.
NOTE: This unit is equipped with a built
in clutching mechanism used to prevent
permanent damage to the unit due to an
obstruction in the tines or overloaded
working conditions. If the clutch is engaged,
the unit will make a loud clicking sound.
This noise will persist until the obstruction or
overload condition is removed.
Unplug prior to attempting to remove
obstructions from tines. The clutch
mechanism is not adjustable by the user.
CAUTION:
Do not attempt to unclog
the tines by dropping or tapping the tool on
the ground. This can damage the unit.
EXTENSION CORD RETAINER
WARNING:
Ensure the trigger switch
is not engaged to reduce the risk of starting
the appliance accidentally.
A cord retainer is incorporated into the rear
of the handle on the power head.
• Near the end of the extension cord, fold
the extension cord to create a loop.
• Feed the loop into the cord retainer
housing (12) as shown in Figure H.
H
12
• Hook the loop onto the cord retainer (13)
so it rests in the cord retainer as shown
in Figure I.
• Plug the extension cord into the power head.
I
13
STORAGE
Remove and clean any debris from the
outside of the cultivator and inside of shroud
before storage. See MAINTENANCE section.
CAUTION:
DO NOT HANG ON THE
SWITCH TRIGGER
NOTE: Do not store the tool on or adjacent
to fertilizers or chemicals. Such storage can
cause rapid corrosion.
PREVENTING CORROSION
WARNING:
WEAR PROPER
GLOVES AND EYE PROTECTION WHEN
CLEANING TOOL.
Fertilizers and other garden chemicals
contain agents that greatly accelerate the
corrosion of metals. If you use the tool in
areas where fertilizers or chemicals have
been used, the tool should be cleaned
immediately afterwards. Wipe all exposed
parts with a damp cloth. You may lubricate
only metal parts with a light petroleum based
oil. When cleaning, DO NOT immerse tool in
water or spray it with a hose.
ACCESSORIES
WARNING: The use of any accessory
not recommended for use with this tool
could be hazardous.
Replacement tines (90615510P) and
spring clip (90506985P) for use with your
tool are available from your local dealer
or authorized service center. If you need
assistance regarding accessories, please
call: 1-800-544-6986.
MAINTENANCE
Use only mild soap and damp cloth to
clean the tool. Never let any liquid get
inside the tool; never immerse any part
of the tool into a liquid. IMPORTANT: To
assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (other
than those listed in this manual) should be
performed by authorized service centers or
other qualified service organizations, always
using identical replacement parts.
Fertilizers and other garden chemicals
contain agents which greatly accelerate the
corrosion of metals. Do not store the tool on
or adjacent to fertilizers or chemicals.
With the battery removed, use only mild
soap and a damp cloth to clean the tool.
Never let any liquid get inside the tool; never
immerse any part of the tool into a liquid.
For assistance with your product, visit our
website www.blackanddecker.com for the
location of the service center nearest you
or call the BLACK+DECKER help line at
1-800-544-6986.
