Black & Decker BPSM1510, Instructions Manual

Page: 12 / 40

12
ENGLISH
Power 1500W
No-Load speed 5500/min
Max Depth 70mm
Installing a New Saw Blade
(UNPLUG THE MITRE SAW)
• DO NOT USE FERROUS METAL or masonry cutting
blades in this saw
• Loosen hex bolt on center cover counter clockwise with
box wrench.
• Lift up the safe cover and center cover.
• Press down the lock to lock spindle.
• Loosen hex bolt clockwise with box wrench, then
dismount the bolt and flange.
• Mount the blade of saw on spindle. Make sure that the
arrow direction on surface of saw blade is same as one
of the cover.
Note: There are two different internal diameters of cutter in
inner plate which have steel stamp marked 25.4mm 16mm.
When mounting, the outer diameter of inner plate must be
correspondent with the internal diameter of saw blade.
• Mount flange and hex bolt.
• Press axle lock and tighten hex bolt counter clock wise
with box wrench fi rmly, then tighten hex bolt clockwise to
fix centre cove r.
Note: Only use attached wrench when mounting or
dismounting saw blade. When dismounting saw blade, lift up
safe cover and centre cover. Loosen hex bolt with box
wrench and disassemble hex bolt, flange and saw blade.
NEVER DEPRESS THE SPINDLE LOCK PIN WHILE THE
BLADE IS ROTATING.
• Be sure to hold the guard bracket down and firmly
tighten the guard bracket screw when you finish
installing the saw blade. Failure to do so will cause
serious damage to the saw.
Specifications
Troubleshooting
Trouble! Saw makes unsatisfactory cuts
What’s wrong? What to do
3. Gum or pitch on blade. 3 Remove blade and
clean with turpentine
and coarse steel wool
or household oven
cleaner.
4. Incorrect blade for work 4. Change the blade.
being done.
Trouble! blade does not come up to speed
What’s wrong? What to do
1. Extension cord is too light 1. Replace with adequate
or too long. size cord.
2. Low house current. 2. Contact your electric
company.
Trouble! Machine vibrates excessively
What’s wrong? What to do
1. Saw not mounted securely. 1. Tighten all mounting
hardware.
2. Stand or bench on 2. Reposition on flat level
uneven floo r. surface.
3. Damaged saw blade. 3. Replace blade.
1. mitre scale not adjusted 1. Check and adjust.
correctly.
2. Blade is not square to 2. Check and adjust.
fence.
3. The disc is perpendicular 3. Check and adjust the
to the table. guide.
4. Workpiece moving. 4. Clamp workpiece to
fence or glue 120 grit
sandpaper to fence
with rubber cement.
Trouble! Material pinches blade
What’s wrong? What to do
1. Cutting bowed material. 1. Position bowed material
as shown in Fig. K.