8
1
Portable
compressor
will not
inflate
(continued)
• The compressor may be
overheated. Press the
compressor power switch to
turn the compressor off. Restart
after a cooling down period of
approximately 30 minutes.
• Check that the unit has a full
charge. Recharge the unit if
necessary.
MAINTENANCE
This unit has been designed to operate over a long
period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon
proper tool care and regular cleaning.
Warning!
Before performing any maintenance or
cleaning of the unit, unplug it from the power supply.
• From time to time wipe the unit with a damp cloth.
Do not use any abrasive or solvent-based cleaner. Do
not immerse the unit in water.
• Clean the outside case of the jump starter with a soft
cloth and, if necessary, mild soap solution.
• Do not allow liquid to enter the unit’. Do not operate
when the battery charger is wet.
• Keep the cords loosely coiled during storage to
prevent damage to the cords.
PROTECTING THE ENVIRONMENT
Correct disposal of this product
This marking indicates that this product
should not be disposed with other
household waste throughout the EU. To
prevent possible harm to the environment
or human health from uncontrolled
waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return
your used device, please use the return and collection
systems or contact the retailer where the product
was purchased. They can take this product for
environmentally safe recycling.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the
demand for raw materials.
Local regulations may provide for separate collection
of electrical products from the household, at municipal
waste sites or by the retailer when you purchase a
new product.
TECHNICAL DATA
Battery Type
12V, 17Ah, sealed lead
acid
Output (instant)
450A
Output (constant for
5 seconds)
300A
Compressor
Pressure (max)
bar/p.s.i 8.27/120
Mains charging adapter
Input
100-240V ac, 50/60Hz
Output
14,5V dc (750mA)
WARRANTY
Our goods come with guarantees that cannot be
excluded under the Australian & New Zealand
Consumer Law. You are entitled to a replacement
or refund for a major failure and compensation
for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods
repaired or replaced if the goods fail to be of
acceptable quality and the failure does not
amount to a major failure.
Baccus Worldwide LLC is confident of the quality of
its products and offers an outstanding warranty. This
warranty statement is in addition to and in no way
prejudices your statutory rights under the Australian &
New Zealand Consumer Law.
If a Baccus Worldwide LLC product becomes
defective due to faulty materials, workmanship or
lack of conformity, within 24 months from the date
of purchase, Baccus Worldwide LLC guarantees to
replace defective parts, repair products subjected to
fair wear and tear or replace such products to make
sure of the minimum inconvenience to the customer
unless:
• The product has been used for trade, professional or
hire purposes;
• The product has been subjected to misuse or
neglect;
• The product has sustained damage through foreign
objects, substances or accidents;
• Repairs have been attempted by persons other than
Baccus Worldwide LLC service staff.
To claim on this warranty, you will need to submit
proof of purchase and return the allegedly defective
product to Baccus Worldwide LLC’s local market
distributor, at your expense.
Please visit our website www.baccusworldwide.com
to register your new Baccus Worldwide LLC product
and to be kept up to date on new products and special
offers. Further information on the Baccus Worldwide
LLC brand and our range of products is available at
www.baccusworldwide.com.
Distributed by:
Directed Electronics
Address:
44 Translink Drive, Keilor Park Victoria Australia 3042
PH:
+ 61 03 8331 4800
Email:
Baccus Worldwide LLC
Weena 290, 3012 NJ Rotterdam or
Postbus 819, 3000 AV Rotterdam
+31(0)10 282 16 11
Cat. # BDJS450IAU
September 2016
RD091216
Printed in China
450 AMP SLIM JUMP STARTER
WITH COMPRESSOR
INSTRUCTION MANUAL
BDJS450IAU_Manual_091216.indd 8-1
9/12/2016 11:57:44 AM
